Welcome to EZvacuum.com Call Toll Free 1-877-693-9822 M-F 9am to 5pm EST Chat Now

Free Shipping on all orders

Bissell Spot Bot suction and Spray Hose Assembly 2036665

203-6665
5.0 out of 5

Availability: In stock

$19.99
Get it by if you order it before 3PM EST and choose two-day shipping
SAVE 10% NOW
Like us on Facebook or Tweet or Rate us on Google and get an instant Coupon Code to use on your current order
click here now
+
-

OR


Bissell Spot Bot  suction and Spray Hose Assembly  2036665

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Details

Bissell SpotBot hose assembly fits all Bissell SpotBot carpet cleaner models i.e. SpotBot Pet, ProHeat Deep Cleaner including 1200, 1200B, 1200A, 1200H, 1200L, 1200Q SpotBot Pet, SpotBot ProHeat Deep Cleaner, SpotBot Pet Deep Cleaner, SpotBot Deep Cleaner and 7887.
Part 203-6665, 2036665
  • You can also find this product in:

Additional Information

SKU 203-6665
Brand Bissell
Manufacturer Bissell



Customer Reviews

Good part ... difficult installation
by Bill on 3/25/14
Quality
Price
Value
The part is identical to the part in the Bot, however there are NO directions on how to install it, which made for a challenge. Once you figure out it's the upper part of the Bot which has to be disassembled, you are on the road to success. After getting the upper portion of the Bot disassembled, you have to disconnect the water dispensing hose from the plastic junction (I had to cut it then get the remaining piece off the junction), you can remove the old hose. Now the real challenge begins, the main plastic hose has an indentation that will accommodate the water hose so you can insert the large hose into the Bot hole. The problem is, the small water hose has to be pushed into the large tube pretty far to make it possible to get the large hose into the bot opening. I found, I could remove the trigger cover and using needle nose pliers, I could pull some of the water hose thru giving enough room to stuff the hose in far enough on the other end to still get a hold of it after inserting the bent end into the Bot. This puts a little kink in the trigger end, but it straightens once you feed the water hose back thru. I used a hair drier to warm the end of the water hose to get it connected to the junction, and don't forget to put the clamp on before connecting the water hose ... also, pay attention to the routing of the water hose when disconnecting it so you can use the same route to install it. Then, just put it back together and test it. Mine worked great and $20 is a lot better than $150 ... enjoy!

Write Your Own Review

You're reviewing: Bissell Spot Bot suction and Spray Hose Assembly 2036665

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Value
Quality
Price