Similar Items
Details
Genuine Shark Navigator HEPA Filter XHF80
Fits Following Shark Models
Shark Navigator NV60, NV6026
Shark Navigator Professional Model NV80
Shark Navigator Professional Model NV70
Shark RotatorĀ® Professional XL Upright Vacuum (NV95)
Shark Navigator Professional Model UV420
Shark Navigator Professional Model NVC80C
Part no # XHF80 , EU-18003
.
Fits Following Shark Models
Shark Navigator NV60, NV6026
Shark Navigator Professional Model NV80
Shark Navigator Professional Model NV70
Shark RotatorĀ® Professional XL Upright Vacuum (NV95)
Shark Navigator Professional Model UV420
Shark Navigator Professional Model NVC80C
Part no # XHF80 , EU-18003
.
How to change XHF80 Filter
To clean the post-motor HEPA filter:
1 Remove the filter cover from the front of the vacuum by pulling up on the tab and pulling the cover away from the vacuum.
2 Take out the HEPA filter by pulling it straight out.
3 Replace it with the XHF80 filter you just bought at EZvacuum.com.
4 After every 3-4 vacuum runs, tap the HEPA filter gently to loosen dirt and debris.
DO NOT put the HEPA filter in the washing machine or dishwasher.
7 Replace the cover by inserting the two tabs into the holes at the bottom and then swinging the cover up until it clicks into place.
To clean the pre-motor filters:
1 Remove the dust cup.
2 Pull the 2 filters out from the top of the motor base.
3 Replace the filter set XFF80 you just bought at EZvacuum.com.
DO NOT put the filters in the washing machine or dishwasher.
4 After everyt 3-4 vacuum runs, you may wash the filter under lukewarm water. Squeeze out excess water and let air-dry for at least 24 hours before replacing. Do not use a hair dryer or other heating methods to dry.
5 Place the felt filter in first, then the foam filter.
6 Replace the dust cup
To clean the post-motor HEPA filter:
1 Remove the filter cover from the front of the vacuum by pulling up on the tab and pulling the cover away from the vacuum.
2 Take out the HEPA filter by pulling it straight out.
3 Replace it with the XHF80 filter you just bought at EZvacuum.com.
4 After every 3-4 vacuum runs, tap the HEPA filter gently to loosen dirt and debris.
DO NOT put the HEPA filter in the washing machine or dishwasher.
7 Replace the cover by inserting the two tabs into the holes at the bottom and then swinging the cover up until it clicks into place.
To clean the pre-motor filters:
1 Remove the dust cup.
2 Pull the 2 filters out from the top of the motor base.
3 Replace the filter set XFF80 you just bought at EZvacuum.com.
DO NOT put the filters in the washing machine or dishwasher.
4 After everyt 3-4 vacuum runs, you may wash the filter under lukewarm water. Squeeze out excess water and let air-dry for at least 24 hours before replacing. Do not use a hair dryer or other heating methods to dry.
5 Place the felt filter in first, then the foam filter.
6 Replace the dust cup
California residents see Prop 65 WARNINGS WARNING! This product contains a chemical know to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warning.ca.gov
- You can also find this product in:
Additional Information
SKU | XHF80 |
---|---|
Brand | Euro Pro |
Manufacturer | EuroPro |