Details
Flat belt for Bissell Aeroswift lightweight compact upright vacuum cleaner models 10099, AeroSwift® Compact Vacuum 1009K, 1009, 10092, 10094, 10096, 10093, PowerSwift Lightweight Compact Vacuum 18082, 1808
Replaces part #160-0319, 1600319, ymh 28950
.
Replaces part #160-0319, 1600319, ymh 28950
.
How to change Bissell Aeroswift Belt
1. Unplug the vacuum from electrical outlet.
2. With rotating brush removed (follow steps from check rotating brush section), grasp old drive belt and remove from motor pulley. If difficult to remove from pulley, use scissors to cut and remove belt.
3. Place the new drive belt over motor pulley and loop other end over rotating floor brush in the space between bristles. NOTE: The space between the motor pulley and the foot covering is tight. Slide the thin side of the belt down between the motor pulley and foot covering and work with your fingers to position under the motor pulley.
4. With drive belt connected to motor pulley, pull the belt over the brush roll and position the floor brush into the brush cover ends. Rotate the brush end opposite of the belt to line up with the brush cover tab. The brush end closest to the belt will slide in the tab without needing to rotate.
5. Replace brush cover and secure with the 3 screws.
1. Unplug the vacuum from electrical outlet.
2. With rotating brush removed (follow steps from check rotating brush section), grasp old drive belt and remove from motor pulley. If difficult to remove from pulley, use scissors to cut and remove belt.
3. Place the new drive belt over motor pulley and loop other end over rotating floor brush in the space between bristles. NOTE: The space between the motor pulley and the foot covering is tight. Slide the thin side of the belt down between the motor pulley and foot covering and work with your fingers to position under the motor pulley.
4. With drive belt connected to motor pulley, pull the belt over the brush roll and position the floor brush into the brush cover ends. Rotate the brush end opposite of the belt to line up with the brush cover tab. The brush end closest to the belt will slide in the tab without needing to rotate.
5. Replace brush cover and secure with the 3 screws.
California residents see Prop 65 WARNINGS WARNING! This product contains a chemical know to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warning.ca.gov
- You can also find this product in:
Additional Information
SKU | 1600319 |
---|---|
Brand | Bissell |
Manufacturer | Bissell |
I have a Bissell Powerswift Compact 18082 sweeper, I need belts for it, trying to find is a headache, I think the number for the belt is1600319.
A:
yes. This will work for 18082
Support answered on January 18, 2019